Skip to content
Burlington & Halton · phones answered 7 daysCall a plumber: (365) 414-5748
Plumbers in BurlingtonHonest plumbing, set in good order.Call
Plumber in work overalls tightening a pipe fitting with a wrench
Tightening a union on a supply line under a sink.
Answered by a plumber
Burlington ยท Halton Region

Plumbers in Burlington

One call reaches a plumber who explains the job before the tools come out.

  • Clogged drains cabled and the clog shown to you
  • Water heaters, sump pumps and leaks fixed same visit when parts allow
  • Restaurants, shops and condo buildings booked around your hours
  • Price explained before any pipe is cut
  • Licensed & insured (details on request)
  • Price before tools
  • Clean, covered work area
  • Tested before we leave
  • Cause firstWe open the trap, the cleanout or the burner door and show you what failed.
  • Price before toolsYou hear the repair and the price before any pipe is cut.
  • Clean work areaDrop cloths under every trap, shoe covers on, wet vac on the truck.
  • Tested before we goLines held under pressure, drains run full, heaters cycled.

Every repair we do

Every service below is a real job we do with our own hands: cabling drains, jetting mains, sweating copper, crimping PEX, setting toilets, swapping water heaters, setting sump pits and cutting in backwater valves. Pick the trouble closest to yours, or call and describe what you see and hear.

Drains and sewers

Hot water and gas

Basements and sumps

Leaks and water quality

Pipes and water lines

Fixtures

Renovation rough-ins

Honest plumbing, set in good order. Clogged drains cabled, split pipes cut out and rejoined, dead water heaters swapped and sump pits brought back to work, in houses and condos across the city.

Two women sharing breakfast at a bright kitchen table
Mornings run on hot water and a draining sink.
Most-booked job

Drain cleaning, done by hand and by machine

Most of what we do in Burlington is drain work. A kitchen sink packed with grease and coffee grounds. A shower trap wound full of hair. A toilet with a wipe lodged in the trapway. A basement floor drain that bubbles up grey water every time the washing machine pumps out. Each one is cleared a different way, and the first job is working out where the blockage sits.

For a single slow fixture we pull the P-trap into a bucket and look. Often the clog is right there. If not, a small drum auger goes through the trap arm and into the branch line in the wall. When several fixtures are slow at once, or the floor drain is backing up, the trouble is in the main, and we go in through the cleanout with a sectional machine and a root cutter. Older Burlington sewer laterals tend to be clay or cast iron, and roots work their way in at the joints.

  • Kitchen sinks: grease, rice, coffee grounds, disposer sludge
  • Showers and tubs: hair and soap scum below the flange
  • Toilets: wipes, cotton and toys in the trapway
  • Floor drains: lint, silt and roots in the main

After the clog comes out we run water through every connected fixture. Where roots or a sag are suspected, we push a camera through the line and play back the footage before suggesting anything bigger.

Drain cleaning details

On the tools

Hands scrubbing a bowl under a running kitchen tap
Everyday dishwashing is where most kitchen clogs begin.
A set of chrome-vanadium wrenches laid out on black
Open-end wrenches sized for supply fittings.
Rocks and calm water along a Lake Ontario shoreline at dusk
The lake that supplies Halton's drinking water.
Ring (365) 414-5748 for a plumber

Describe the drain, pipe or fixture and get a straight answer on the phone.

Call now

Burlington neighbourhoods and the pipes in them

The plumbing in a Burlington house depends mostly on when it was built. Lakeside streets and the older core still run on galvanized water pipe, cast-iron soil stacks and clay sewer laterals beneath old maples. The 1960s and 70s suburbs run on copper that is starting to pinhole. Houses from the 1980s to the mid-90s often carry grey Poly-B. The newest subdivisions north of the 407 lean on hard-working sump pumps. Here is what we tend to find, area by area.

Call before the water spreads

If water is spreading, close the main valve near the meter first. Then tell us which pipe or fixture the water comes from, whether it runs clean or grey, and roughly when the house was built.

  1. Main valve closed, power off to wet areas
  2. You call and describe the leak or backup
  3. A plumber arrives with the right parts and tools
  4. Repair, pressure test, clean up
Call a plumber · (365) 414-5748